Mazda Tribute

On certain vehicles registered and operated in areas where road salt is used on the roadways during winter months for extended time periods (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland-Labrador), the forward attachment point for the lower control arm may separate from the vehicle's subframe. This could affect vehicle handling and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will install a newly designed reinforcement cross-brace.

Certain vehicles may have been originally equipped with a brake master cylinder reservoir cap that could leak. If brake fluid leaks from the cap, it could come in contact with the ABS module wiring harness connector. The same vehicles were previously involved in campaign 2007119 to address potentially missing or misplaced seals in the wiring harness connector to the ABS module electronic control unit. If this repair wasn’t done correctly, brake fluid leaking from the reservoir cap could corrode the ABS module electrical connector. This could result in vehicle fire causing property damage and/or personal injury. Correction: Dealers will replace the brake master cylinder reservoir cap and modify the ABS electrical system. Note: Owners are advised to park the vehicle outdoors until the remedy is applied.

On certain vehicles, the windshield wiper motor may have been produced without grease applied to the output shaft gear. After a period of continuous use on the high-speed setting, lack of grease may cause the gear teeth to distort and/or fracture during operation, resulting in the loss of wiper function. Correction: Dealers will inspect and, if required, apply grease to the output shaft gear.

On certain vehicles equipped with 3.0L V6 engines, the accelerator cable's inner liner may, over time, migrate out of the conduit at the dash panel fitting during vehicle operation. The liner may migrate to the point that it contacts the accelerator pedal arm. Under these conditions the liner may prevent the pedal from fully returning, which may not allow the throttle body to fully return to the "idle" position. Typically the condition results in a progressive increase in the "idle" speed if liner migration continues over time, but may cause a more sudden increase if a greater portion of the cable moves at one time. An unexpected increase in "idle" speed may result in longer than expected stopping distances, which could potentially lead to a crash. Correction: Dealers will replace the accelerator cable.

On certain vehicles, a post molded into the inside surface of the front safety belt buckle cover may fracture. The fractured buckle cover post may affect the buckle function and may exhibit either "no latch" - an overt condition as the tongue will not latch into the buckle, or "partial latch" - likely an overt condition because, although the tongue can be inserted into the buckle and appear to be engaged, it will release from the buckle without the push button being depressed when a relatively low load is applied such as when an occupant moves slightly in the seat. Correction: Dealer will replace both front safety belt buckle covers.

On certain vehicles, the windshield wiper linkage may disengage due to a broken ball socket which will likely result in sudden and complete loss of the windshield wiper function, or of the wiper function on the driver side only, with no warning to the driver. Correction: Windshield wiper module will be inspected and replaced if necessary.